This is an old revision of the document!
Timer Output
Configuration Registers
Data Registers
| CNT | Counting register |
Upcounting
Downcounting
Up/Down counting
Clock Source
Output Compare
Registers
Configuration Registers
CR1
| DIR | 0 | Counter used as upcounter |
| 1 | Counter used as downcounter | |
| This bit is readonly in center-aligned or encoder mode | ||
| OPM | 0 | Counter is not stopped at update event |
| 1 | Counter stops at the next update event | |
| CEN | 0 | Counter disabled |
| 1 | Counter enabled | |
CR2
| MMS | 000 | Reset |
| 001 | Enable | |
| 010 | Update | |
| 011 | Compare Pulse | |
| 100 | Compare OC1REF signal is used as TRGO | |
| 101 | Compare OC2REF signal is used as TRGO | |
| 110 | Compare OC3REF signal is used as TRGO | |
| 111 | Compare OC4REF signal is used as TRGO | |
| CCDS | 0 | CCx DMA request sent when CCx event occurs |
| 1 | CCx DMA request sent when update event occurs |
PSC
ARR
DIER
| TDE | 0 | Trigger DMA request disabled |
| 1 | Trigger DMA request enabled | |
| CCxDE | 0 | CCx DMA request disabled |
| 1 | CCx DMA request enabled | |
| UDE | 0 | Update DMA request disabled |
| 1 | Update DMA request enabled | |
| TIE | 0 | Trigger interrupt disabled |
| 1 | Trigger interrupt enabled | |
| CCxIE | 0 | CCx interrupt disabled |
| 1 | CCx interrupt enabled | |
| UIE | 0 | Update interrupt disabled |
| 1 | Update interrupt enabled |
CCMR1/2
| CCxS | 00 | CCx channel is configured as output |
| 01 | CCx channel is configured as input, ICx is mapped directly | |
| 10 | CCx channel is configured as input, ICx is mapped crossed | |
| 11 | CCx channel is configured as input, ICx is mapped on TRC | |
| CCxS bits are only writeable when the channel is off (CCxE = 0, CCER) | ||
Input Configuration
Output Configuration
| OCxM | 000 | Frozen Compairson of CNT and CCRx has no effect on OCxREF |
| 001 | Active OCxREF high if CNT equals CCRx | |
| 010 | Inactive OCxREF low if CNT equals CCRx | |
| 011 | Toggle OCxREF toggles if CNT equals CCRx | |
| 100 | Force Inactive OCxREF forced low | |
| 101 | Forced Active OCxREF forced high | |
| 110 | PWM 1 OCxREF high if CNT < CCRx | |
| 111 | PWM 2 OCxREF low if CNT > CCRx |
SMCR - Slave Mode Control Register
ETP - External Trigger Polarity
| 0 | ETR is not inverted, active at high level or rising edge |
| 1 | ETR is inverted, active at low level or falling edge |
ECE - External Clock Enable
| 0 | External clock mode 2 disabled |
| 1 | External clock mode 2 enabled. Clock enabled by any active edge on ETRF |
CCER
EGR
SR
Data Registers
CNT
CCRx
Legend
