This is an old revision of the document!
External Interrupts
The EXTI controller consists of 23 edge detectors, which can be configured individually.
EXTI Lines
| 0..15 | EXTI lines 0..15 correspond to the GPIO pins 0..15 |
| 16 | PVD interrupt |
| 17 | RTC Alarm A & B interrupt |
| 18 | USB OTG FS interrupt |
| 19 | Ethernet wakeup |
| 20 | USB OTG HS interrupt |
| 21 | Tamper & time stamp interrupt |
| 22 | RTC wakeup interrupt |
Configuration Register
SYSCFG - EXTICRx
EXTICR1
External interrupt configuration register 1
EXTICR2
External interrupt configuration register 2
EXTICR3
External interrupt configuration register 3
EXTICR4
External interrupt configuration register 4
| EXTIx | 0000 | GPIOA pin x (reset state) |
| 0001 | GPIOB pin x | |
| … | ||
| 1010 | GPIOK pin x |
EXTI_RTSR / FTSR - Rising / falling trigger selection register
| TRx | 0 | Trigger for EXTI line x disabled (reset state) |
| 1 | Trigger for EXTI line x enabled |
EXTI - IMR
Interrupt mask register
| MRx | 0 | Interrupt request for EXTI line x masked (reset state) |
| 1 | Interrupt request for EXTI line x unmasked |
EXTI - PR
Pending register
| PRx* | 0 | No trigger request occurred |
| 1 | Selected trigger request occured |
* This bit is set when the selected edge event arrives on the external interrupt line x. This bis is cleared by programming it to '1'
Programming Example
Setup Peripheral (e.g. GPIOA Pin 5)
#include "reg_stm32f4xx.h" RCC->AHB1ENR |= (0x1 << 0u); /* Enable GPIOA clock */ /* Configure GPIO pin A.5 as input. */ GPIOA->MODER &= ~(0x3 << 10u); /* Clear existing mode bits 10 and 11. */ GPIOA->PUPDR &= ~(0x3 << 10u); /* Clear existing pull-up/-down bits 10 and 11. */ GPIOA->PUPDR |= (0x1 << 10u); /* Set pin 5 to pull-up mode. */
Setup SYSCFG
To choose which GPIO peripheral should trigger EXTI line 5 you have to configure the SYSCFG register.
#include "reg_stm32f4xx.h" SYSCFG->EXTICR2 |= (0u << 4u); /* Set EXTI5 to GPIOA. */
Setup EXTI
#include "reg_stm32f4xx.h" EXTI->RTSR |= (0x1 << 5u); /* Trigger on rising edge. */ EXTI->IMR |= (0x1 << 5u); /* Unmask interrupt line. */
Setup NVIC
#include "reg_stm32f4xx.h" NVIC->ISER0 |= (0x1 << 23u); /* Enable EXTI5 interrupt. */