GPIO over MCU

These two ports are directly connected to the GPIO ports A and B on the microcontroller.
All functions of theese GPIO ports are available.

This functionality is independent of the CT Board mode.
Supported modes: Available in all modes.


Programming Example

To configure and use these Ports, setup GPIO port A / B on the microcontroller.

Diagram

Only pins 0..11 are connected to P5 / P6! The other 4 pins are used for 5V, 3.3V and GND.




  • ctboard/peripherals/gpio_mcu.txt
  • Last modified: 2016/02/25 11:39
  • by feur