====== HEXSW ======

The HEX switch on the CT Board can switch through 16 different states (4 bit). \\ \\

> {{ctboard:ctboard_mode_1.svg?48px }} {{ctboard:ctboard_mode_2.svg?48px }} {{ctboard:ctboard_mode_3.svg?48px }} {{ctboard:ctboard_mode_4.svg?48px }} Please make sure the CT Board is in the correct mode.
> Supported [[ctboard:mode_switch|modes]]: **1**, **2**, **3**, **4** 
\\

===== Registers =====

**Caveat:** Register bits [7:4] are read as '1' and therefore need to be masked.

The register is read only.

\\ {{ctboard_hexsw_reg.svg}} \\ \\

===== Diagram =====

\\ {{:ctboard:peripherals:ctboard_hexsw.svg?700em}} \\ \\

===== Programming Example =====

The code snippets below show how to use the HEXSW.

<code c>
#include "reg_ctboard.h"

uint8_t data = CT_HEXSW;                    /* Read HEXSW into the lower nibble of a byte. */
</code>
\\

<code asm>
ADDR_HEXSW      EQU      0x60000211
                
                LDR      r0, =ADDR_HEXSW
                LDRB     r1, [r0, #0]       ; Read HEXSW into the lower nibble of a byte.
</code>
\\