Differences

This shows you the differences between two versions of the page.

--- stm32:peripherals:timer_input [2016/06/27 12:21] – [CR1] feur
+++ stm32:peripherals:timer_input [2016/06/28 11:53] (current) – removed feur
@@ Line 1: / Line 1: @@
-====== Timer Input ======
-\\ {{timer_clock.svg}} \\ \\
-===== Programming Example =====
-The code snippet bellow shows how to configure and use a GPIO pin as input.
-<code c>
-#include "reg_stm32f4xx.h"
-/* TO-DODELI DOO. */
-</code>
-\\
-> {{logo_hal.svg?72px |}} **Hardware Abstraction Layer**
-> [[https://ennis.zhaw.ch/hal/structreg__tim__t.html | Registry Types]]
-> [[https://ennis.zhaw.ch/hal/hal__timer_8h.html | InES Timer HAL Interface]]
-\\
-===== Configuration Registers =====
-==== CR1 ====
-Configuration register 1
-\\ {{timer_reg_cr1.svg}} \\ \\
-|< 100% 5em 5em >|
-|CKD|00|t<sub>DTS</sub> => t<sub>CKINT</sub>|
-|:::|01|t<sub>DTS</sub> => 2 · t<sub>CKINT</sub>|
-|:::|10|t<sub>DTS</sub> => 4 · t<sub>CKINT</sub>|
-|:::|11|Reserved|
-==== SMCR ====
-Slave mode control register
-\\ {{timer_reg_smcr.svg}} \\ \\
-|< 100% 5em 5em >|
-|ETR|0|ETR is **not** inverted, active at high level or rising edge|
-|:::|1|ETR is inverted, active at low level or falling edge|
-|ECE|0|External clock mode 2 disabled|
-|:::|1|External clock mode 2 enabled. Clock enabled by any active edge on ETRF|
-===== Data Registers =====
-==== CNT ====
-Count register
-\\ {{timer_reg_cnt.svg}} \\ \\
-===== Legend =====
-\\ {{legende.svg}} \\ \\