Differences

This shows you the differences between two versions of the page.

--- ctboard:peripherals:memory_bus [2016/02/25 11:40] – feur
+++ ctboard:peripherals:memory_bus [2017/08/29 09:37] (current) – [External Memory Bus] feur
@@ Line 1: / Line 1: @@
 ====== External Memory Bus ======
-The CT Board is connected to the microcontroller over SRAM interface. This interface is also available on ports P1..4. \\ \\
+The CT Board is connected to the microcontroller through the SRAM interface. This interface is also available on ports P1..4. \\
+The full SRAM interface is connected. \\ \\
-===== Full Bus =====
+> {{ctboard:ctboard_mode_2.svg?48px }} Please make sure the CT Board is in the correct mode.
-The full interface is connected. \\ \\
-> {{ctboard:ctboard_mode_2.svg?48px }} This functionality is independent of the CT Board mode.
 > Supported [[ctboard:mode_switch|mode]]: **2**.
 \\
-==== Pin Out ====
+===== Pin Out =====
 \\ {{ctboard_gpio_stm32_reg.svg}} \\ \\
-===== Visualization on Oscilloskope =====
-For educational purpouse there is a mode to visualize the bus on a oscilloskope. \\
-The ports are specially configured to directly plug in the logic probe of a Tektronix logic analyzer. \\ \\
-> {{ctboard:ctboard_mode_3.svg?48px }} This functionality is independent of the CT Board mode.
-> Supported [[ctboard:mode_switch|mode]]: **3**.
-\\
-==== Pin Out ====
-\\ {{ ctboard_gpio_probe.png?300em}}
-   {{ctboard_gpio_probe_reg.svg}} \\ \\