Differences

This shows you the differences between two versions of the page.

--- ctboard:peripherals:button [2016/02/25 10:45] – feur
+++ ctboard:peripherals:button [2026/06/25 14:52] (current) – [Programming Example] scbj
@@ Line 1: / Line 1: @@
-====== Button ======
+====== Buttons ======
 The 4 buttons on the CT Board are **"active-high"**, e.g. a pressed button is read as logical **"1"**, and debounced. \\
 The buttons are accessible over the memory mapped interface or on [[stm32:peripherals:gpio|GPIO port C]]. \\ \\
-> {{ctboard:ctboard_mode_1.svg?48px }} {{ctboard:ctboard_mode_2.svg?48px }} {{ctboard:ctboard_mode_3.svg?48px }} Please make sure the CT Board is in the correct mode.
+> {{ctboard:ctboard_mode_1.svg?48px }} {{ctboard:ctboard_mode_2.svg?48px }} {{ctboard:ctboard_mode_3.svg?48px }} {{ctboard:ctboard_mode_4.svg?48px }} Please make sure the CT Board is in the correct mode.
-> Supported [[ctboard:mode_switch|modes]]: **1**, **2**, **3**
+> Supported [[ctboard:mode_switch|modes]]: **1**, **2**, **3**, **4**
-===== Programming Example =====
-The code snippet bellow shows how to use the Buttons.
-<code c>
-#include "reg_ctboard.h"
-uint8_t data = CT_BUTTON;       /* Read all buttons into the lower nibble of a byte. */
-</code>
 \\
@@ Line 27: / Line 17: @@
 \\ {{:ctboard:peripherals:ctboard_button.svg?700em}} \\ \\
+===== Programming Example =====
+The code snippets below show how to use the buttons.
+<code c>
+#include "reg_ctboard.h"
+uint8_t data = CT_BUTTON;                   /* Read all buttons into the lower nibble of a byte. */
+</code>
+\\
+<code text>
+.equ ADDR_BUTTON,   0x60000210
+        ldr         r0, =ADDR_BUTTON
+        ldrb        r1, [r0, #0]       // Read all buttons into the lower nibble of a byte.
+</code>
+\\