Differences

This shows you the differences between two versions of the page.

--- ctboard:peripherals:7segment_bin [2017/09/19 07:31] – ruan
+++ ctboard:peripherals:7segment_bin [2022/12/23 11:07] (current) – [Programming Example] ruan
@@ Line 1: / Line 1: @@
-====== 7-Segment Binary Interface ======
+====== 7-Segment Display - Binary Interface ======
-Additionally the display can be used as HEX display. All 4 displays can directly show a 16 bit binary value. \\
+The four 7-segment displays can jointly display a 16-bit value as a four digit HEX number. \\
-In this mode the display can't be switched off, use the [[7segment_raw|raw interface]]. \\ \\
+In this mode the display can't be switched off, use the [[7segment_raw|segment control interface]] instead. \\ \\
 > {{ctboard:ctboard_mode_1.svg?48px }} {{ctboard:ctboard_mode_2.svg?48px }} {{ctboard:ctboard_mode_3.svg?48px }} {{ctboard:ctboard_mode_4.svg?48px }} Please make sure the CT Board is in the correct mode.
 > Supported [[ctboard:mode_switch|modes]]: **1**, **2**, **3**, **4**
 \\
+===== Registers =====
+The registers are read / write.
+\\ {{ctboard_7seg_bin_reg.svg}} \\ \\
+===== Diagram =====
+\\ {{ctboard_7seg_bin.svg?700em}} \\ \\
 ===== Programming Example =====
-The code snippet bellow shows how to use the 7 segment display as HEX display.
+The code snippet below shows how to use the 7-segment display as HEX display.
 <code c>
@@ Line 29: / Line 39: @@
 \\
-===== Registers =====
-The Registers are read / write.
-\\ {{ctboard_7seg_bin_reg.svg}} \\ \\
-===== Diagram =====
-\\ {{ctboard_7seg_bin.svg?700em}} \\ \\