Differences

This shows you the differences between two versions of the page.

--- ctboard:peripherals:7segment [2016/02/10 13:03] – [Registers] feur
+++ ctboard:peripherals:7segment [2018/01/14 09:30] (current) – ruan
@@ Line 1: / Line 1: @@
-====== 7 Segment Display ======
+====== 7-Segment Display ======
-There are 4 7 segment displays mounted on the CT Board. The displays can be accessed over two different interfaces:
+The CT Board provides four 7-segment displays. The displays can be accessed through two different interfaces:
-  * The [[#hex_display|binary]] interface, for HEX representation of binary values
+  * The [[7segment_bin|binary]] interface, for HEX representation of binary values
-  * The [[#segment_control|"raw"]] interface, for independent controll over each segment
+  * The [[7segment_raw|"segment control"]] interface, for independent control of each segment
 Depending on the used addresses the display will switch automatically. \\ \\
-> {{ctboard_mode_1.svg?48px }} {{ctboard_mode_2.svg?48px }} {{ctboard_mode_3.svg?48px }} Please make sure the CT Board is in the correct mode.
-> Supported modes: **1**, **2**, **3**
-===== Segment Control =====
-This is the "raw" interface. Each segment of the display can be controled independently. The segments are **"active-low"**, e.g. the segment is on if a logical "0" is written to it.
-==== Registers ====
-The Registers are read / write.
-{{ctboard_7seg_raw_reg.svg}}
-==== Diagram ====
-\\ {{ctboard_7seg_raw.svg?700em}} \\ \\
-===== HEX Display =====
-Additionally the display can be used as HEX display. All 4 displays can directly show a 16 bit binary value. \\
-In this mode the display can't be switched off, use the [[#segment_control|raw interface]]. \\ \\
-==== Registers ====
-The Registers are read / write.
-\\ {{ctboard_7seg_bin_reg.svg}} \\ \\
-==== Diagram ====
-\\ {{ctboard_7seg_bin.svg?700em}} \\ \\