Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
| stm32:peripherals:rtc_wakeup [2017/10/24 10:45] – [Setup wakeup timer] kjaz | stm32:peripherals:rtc_wakeup [2021/09/06 07:29] – frtt | ||
|---|---|---|---|
| Line 90: | Line 90: | ||
| |WUTWF*|0|Wake up timer configuration not allowed| | |WUTWF*|0|Wake up timer configuration not allowed| | ||
| |:::|1|Wake up timer configuration allowed| | |:::|1|Wake up timer configuration allowed| | ||
| + | |WUTF||Wake up timer flag is set by hardware when wakeup counter reaches 0 and cleared by software by writing 0.|| | ||
| * This bit is set, after the WUTE bit (control register) has been set to 0, and reset by hardware. | * This bit is set, after the WUTE bit (control register) has been set to 0, and reset by hardware. | ||
| + | |||
| + | ===== Back domain control register ===== | ||
| + | |||
| + | ==== RCC_BDCR ==== | ||
| + | Back domain control register | ||
| + | |||
| + | \\ {{rcc_reg_bdcr.svg}} \\ \\ | ||
| + | |||
| + | |< 100% 5em 5em >| | ||
| + | |RTCEN*|0|RTC clock disabled| | ||
| + | |:::|1|RTC clock enabled| | ||
| + | |RTCSEL|00|No clock| | ||
| + | |:::|01|LSE oscillator clock used as the RTC clock| | ||
| + | |:::|10|LSI oscillator clock used as the RTC clock| | ||
| + | |:::|11|HSE oscillator clock divided by a programmable prescaler(selection Through RTCPRE[4:0] bits in the RCC clock configuration register (RCC_CFGR)) used as the RTC clock| | ||
| + | |||